How to Attach Two Phone Wires Together to Make One

Safiretr

Editor

posted on 18 years ago — updated on 1 second ago

42
views

If you need a long phone cable in a pinch two shorter cables can be quickly spliced together until you can buy a real cable.

Things You Should Know

The first wire should be cut with the wires in BRGY order, and the second wires should be cut with the wires in YGRB order.
You can twist the wires together to splice them, but soldering them together would be better if you have access to a soldering gun.
If you don't have electrical tape to connect the two wires, you can use any other tape as a temporary fix.

Cut the wires . Cut one plastic connector (plug) off of each wire, you should used dykes or wire cutters, but if you don’t have those a knife or scissors will do. It is important that you cut opposite sides off otherwise the you stand a 50/50 chance of screwing up step three. If you look at the connectors with the hook down you should see four wires in this order Black, Red, Green, Yellow from left to right and the other connector will have them in reverse order. Cut the connector with the wires in BRGY off the first wire then the connector with the YGRB off the second wire. (See diagram) Viewed with hooks facing down on all connectors. Cut the connector with the wires in BRGY off the first wire then the connector with the YGRB off the second wire.WireCutDiag.JPG

Strip the insulation back . Using a sharp knife or razor blade remove an inch of the outer plastic covering from the end you just cut. This should reveal four wires, strip 1/2" off of each of these individual wires.

Properly match the wires . If you cut the wires properly you should be able to match up the colors if you didn’t just make sure the wire that is on the far left of one connector is on the far right on the other side of the wire. (See diagram) Viewed with hooks facing down on all connectors. (TOP) If the wires were properly cut they can be spliced by matching up the colors. (BOTTOM) If they wires were not properly cut be sure the wires are in reverse order (from left to right) ie bottom wire remains on bottom.WireSpliceDiag.JPG

Connect the wires . Twist each wire with the wires you are connecting it to. If you have access to a soldering iron you should solder them together.

Individually tape each connection . If you have electrical tape (black plastic tape) on hand use this, otherwise any tape can be used for a TEMPORARY fix. If you do not tape each wire individually the wires could short and your cable will be useless.